To do so, first get the IP address of the board: The board can also be accessed via the network through Ethernet connection, using ssh. You can for example reboot the board and see the boot sequence. The setup is correct when you can send Linux ® commands through the terminal emulator and get feedback. More information on the board serial port can generally be found in the hardware user manual of the board.
Open a terminal emulator application on your PC and configure with the serial setup menu the USB port to be used and the baud rate of the serial link (in general 115200 baud).Īny of the Windows ® terminal emulator applications can be used. On the terminal, the prompt is changed information on Minicom can be found at the following link. See below example for a standard UART (ttyS0) or STLink interface (ttyACM0): See How to use TTY with User Terminal article to find the appropriate tty instance to be used. Hardware flow control is generally set to off (default value is on) and a baud rate of 115200 is usual. The UART configuration that is set with the below command has to match the one from your board: to be checked within board user manual. If a message indicating Minicom does not exist, then install it:.You need first to check that Minicom is installed on your PC. Pictures describing board connections can be found in Category:STM32_MPU_boards 1.1 On Linux ® PC 1 Remote terminal via serial link (UART/USB)ġ Remote terminal via serial link ( UART/USB) įirst of all, you need to connect your host PC to the board via UART.ĭepending on the board, some additional materials may be needed to physically interconnect the board to the console serial port (extension board or adapter to interconnect the UART from the board to the USB PC input).
0 kommentar(er)
